JavaScript is disabled. Because that a much better experience, please permit JavaScript in your browser before proceeding.


You are watching: John deere hydro 165 drive belt

I have a JD Hydro 165 that lost its journey belt. Ns picked increase a brand-new belt (M84075), took off the PTO/clutch, obtained the belt top top the infection pulley, climate on the pulley nearest the transmission that has an idler top top the very same bracket. This is where I acquire stuck! What is the place of the idler, where and which direction is the 90 level twist in the belt and correct routing that the belt?It is different from the JD175, due to the fact that I don’t have 2 pulleys by the PTO.A diagram would be helpful?Thanks
*

*

1948 Allis UC Hi-Crop Cane. 1941 Allis WC1948 Allis G with front end loader 1948 Allis G with LH & RH disc4x 1948 Allis G. 1949 Allis G. 1954 Allis G1972 MF 135. 1989 Ford 345C TLB
Joe,Thanks, ns saw most of the same photo online yet it to be too tough too see and read. Your are much better, thanks! The problem is at the top of page 50-10-4, my JD165 does not have that wheel just listed below the engine pulley. Mine JD165 has a pulley close to the infection thats ~ above a braket with an idler. I also heard the 90 degree twist has to be in the correct place so you move forward (not backwards) once the drive is in the front position. Any type of suggestions?Thanks
*

1948 Allis UC Hi-Crop Cane. 1941 Allis WC1948 Allis G v front end loader 1948 Allis G with LH & RH disc4x 1948 Allis G. 1949 Allis G. 1954 Allis G1972 MF 135. 1989 Ford 345C TLB


See more: Warrens Cranberry Fest Warrens Cranberry Festival September 25

Joe,Thanks, that is the photo (page 50-10-8) i am handle with. That v-Grove idler (F) and Flat idler (E) ~ above the same bracket is an installed just front (towards prior of tractor) the the transmission.I worked ON that TODAY and also HERE IS THE resolve FOR A HYDRO 165.The flat idler swings up (towards the front of the tractor), over the v-Grove idler so that the level idler pushes under on the belt prior to reaching the v-Grove idler than around the sheave on the transmission.The belt climate rotates to the ideal 90 degrees, and left of the transmission linkage (picture in ~ bottom of web page 50-10-4) to with the engine pulley. The belt then remains to the left of the steering rod however right the transmission linkage (picture in ~ bottom of page 50-10-4) rotating in the contrary direction. The belt 보다 finishes ~ above the transmission pulley.You execute not have to remove the steering rod however removing the bracket (plus tie rod from wheel) walk help. Friend do need to remove the infection linkage.First time should take 2 hours.I expect this help anyone else v a Hydro 165.