Depending on just how comfortable you room under the hood of your Dodge, girlfriend can conveniently replace her IAC valve in much less than 20 minutes. Even if you"re much more novice 보다 natural, replacing her IAC valve is a fairly straightforward DIY project.
You are watching: 2000 dodge durango idle air control valve location
This article applies to the second Generation Dodge lamb (1994-2001).
The IAC valve in her Dodge ram monitors and also regulates exactly how much wait enters your engine as soon as you idle. Your car can stall if her IAC is can not to store the right amount of air flowing right into your engine. If her Dodge Ram begins stalling each time friend idle, climate it"s likely time to change your IAC valve. Some Dodge ram owners introduce cleaning your IAC valve and seeing if the resolves the problem before replacing it. But due to the fact that you"ll still need to remove the IAC valve to clean it and also the expense of a brand-new one is not that high, friend may also replace it to aid improve her vehicle"s performance.
Materials NeededNew IAC valveSocket wrenchLong driver wrenchPliersFlashlight (optional)
Step 1 – Prepare to replace your IAC valve
Leave your car parked for at the very least an hour prior to replacing her IAC valve. As soon as the hood is cool to the touch, open it and lock that in location with the hood prop.
Step 2 – locate the IAC valve
Look because that the IAC valve, which girlfriend will uncover on the throttle body. The IAC valve is cylindrical, and there is an electrical connector coming out of it.
Step 3 – eliminate the electrical connector
Pull the electrical connector turn off of the IAC valve and collection it aside. Be cautious not to damage it, as you’ll reconnect it to the new IAC valve. As soon as you’ve eliminated the electrical connector, you should see 2 screws holding the IAC in place.
Step 4 – remove the 2 screws
Since friend will should work around the fuel bridge, use a lengthy driver socket and pair of pliers to eliminate the very first screw. If the fuel bridge is no in the way, climate you can simply usage a driver socket. Through the flex drive over the bridge, you easily can access and remove the second screw holding the IAC in place.
Step 5 – eliminate the IAC valve
Pull the IAC valve right off the the accelerator body.
See more: Scot-Free In A Sentence - Phrase Of The Week: To Get Off Scot Free
Step 6 – replace the IAC valve
Install your IAC valve by reversing the procedures you take it to eliminate the old IAC valve:Insert new IAC valve. Be certain to align the holes on the valve with the screw holes. Depending upon how lot light friend have, you may need to usage a flashlight to see and confirm the you’ve to adjust the holes.Insert each screw, and then use your socket wrench to tighten both.Reconnect the electrical connector.Finally, close the hood.