This write-up was donated by "FordMan". This page contains quite a couple of large images. It will take a couple of minutes to load.

You are watching: 1994 ford f150 fuel filter location

I would encourage girlfriend to read the whole instructions prior to performing this. Enjoy.

Disclaimer: Please keep in mind that these articles are posted strictly for informational andeducational purposes only. FordF150.net is notresponsible for any type of modifications you might make to her vehicle, no one the resultsyou might have. Performing few of the procedures shown on this site may void yourwarranty. If in doubt, examine with Ford or your regional dealer because that assistance.

I had a brainstorm awhile earlier (it happens) and thought it might be helpful toeveryone questioning if there were some images to guide us. I chose to perform thatwhen I replaced the filter on my folks" "96 F150. It provides the exact same filter together thenewer F150s, same fittings, etc. The pictures aren"t as clear together I"d have liked,but ns was trying to do whatever one handed in the driveway. Prior to you start,a native on safety. Never DO THIS v A hot ENGINE! always USE EYEPROTECTION!! execute NOT SMOKE when PERFORMING maintenance ON A FUEL SYSTEM!!
*Webmasters Note* - You need to release the fuel push in the fuel heat orgas will literally spray everywhere. Top top the passengers side fuel rail (on theengine), over there is a Schrader valve i beg your pardon you can depress and also it willde-pressurize the lines. Sorry, ns don"t have actually a picture of it.

So right here goes:This is the tool I used, a K-D 3321, available at assorted auto components storesfor approximately $12. Usage the smaller sized 5/16" end.

*
This is what points look like prior to you start. Keep in mind the safety and security clip ~ above theend that the fuel line wherein it mates to the filter. Eliminate this through squeezing ittogether and unhooking the tiny latch. Your new filter comes with new clips,but I like the factory worry as they"re rather sturdier for this reason I always savethem.
*
After you"ve gotten rid of the safety clip, on slide the fuel line away from thefilter for this reason you"ve got enough room come insert the tool. Top top this certain vehicle,one the the fuel tanks interfered with my utilizing the tool, therefore I had actually to on slide thefilter partly out the the bracket to obtain access. No huge deal. Push the toolin come the fuel heat (away indigenous the filter) and also listen/feel because that a click toindicate you"ve disengaged the locking maker from the filter
*
Once you"ve disengaged, pull the line far from the filter. In ~ this pointyou"ll start getting some fuel draining out. I choose to take the dust lid fromthe new filter and place it over the discharge finish of the old filter to controlthe mess. Shot to move the fuel heat so the it"s raised to minimization fuel leakagefrom there as well.
*
I"d like to pause right here and also re-emphasize safety. I was not wearing anyeye protection as soon as I began this. The was exceptionally foolish of me and I paidfor the oversight when a small amount of petrol splashed in mine eye. I had tostop what i was doing and flush the eyeball. NO faster way IN THE civilization IS WORTHYOUR EYESIGHT OR SAFETY!!! ns was lucky and didn"t cause any kind of serious injury tomyself, however it did burn like heck. SAFETY, SAFETY, SAFETY!!! i CANNOTEMPHASIZE that ENOUGH!!!I then moved on come removing the fuel heat from the inlet next of the filter.Everything that was said earlier uses here, too.
*
Here"s the old filter, disconnected and also ready to come out.

See more: How Did Hellenistic Ideas Spread Throughout Asia? ? Alexander The Great And The Hellenistic Age

*
Here is a check out of the locking an equipment within the fuel lines. Note the"teeth." These are springs the lock ~ above the raised flange that the fuelfilter. Once you insert the device to disconnect, friend are pushing in on thesesprings
*
When you"re prepared to install the brand-new filter, insert it into the parentheses andpress the fuel present on come the brand-new filter. Just as you felt/listened because that a clickwhen removing the fuel lines, listen/feel for a click during installation
*
After you"ve hooked the fuel lines come the new filter, download the safetyclips and you"re done. It"s the easy.
*